How to: Jailbreak/Unlock iPhone 3.0 - Windows PC redsn0w Edition

Disclaimer - Neither TiPb nor I take any responsibility for any problems/issues/bricking/etc. that may occur while using this software to modify your iPhone. Please be aware of what you are doing. This will NOT work with iPhone 3GS. There has been a lot of buzz going on in the forums regarding jailbreaking the iPhone 3.0 software [...]

Disclaimer - Neither TiPb nor I take any responsibility for any problems/issues/bricking/etc. that may occur while using this software to modify your iPhone. Please be aware of what you are doing. This will NOT work with iPhone 3GS.

There has been a lot of buzz going on in the forums regarding jailbreaking the iPhone 3.0 software lately, and a lot of questions to go along with it!. Today we’re going to take a deeper look at the exact steps you have to take to get your iPhone 3G with the 3.0 software, jailbroken on your Windows PC machine.

Let’s get started, after the jump!

Get the tools

First and foremost make sure your iPhone is updated to the 3.0 firmware. If you’re not yet running 3.0, update via iTunes.

All good? Okay, next make sure your iPhone is not connected to your PC. Next you will need to download the following files:

• redsn0w 0.7.2

• iPhone OS 3.0 for iPhone 3G (IPSW)

Jailbreak Process

Now double click on the redsn0w file you just download to open the redsn0w application. You will then be prompted to select the 3.0 IPSW file you downloaded. Do as instructed now. Once it is successfully identified press next to continue.

Now you will have to select whether you’d like Cydia, Icy, or both installed on your phone. You must install at least one of them. Make sure your choices are checked and press next.

Next you will be connecting your iPhone 3G to your PC. Once your device is connected, hold the power button until the “Slide to Power Off” appears - then slide to power it off. Press next.

Redsn0w will not put your iPhone 3G into DFU mode. Be sure to follow the onscreen instructions exactly. Start by holding down the power button for 3 seconds.

Hold down both both the power button as well as the home button for 10 seconds.

Finally release the power button while continuing to hold the home button down until redsn0w detects your iPhone 3G.

The device will now reboot once it is detected by redsn0w.

Redsn0w will now begin the process of uploading the new ramdisk. Once this is complete you will be notified that the jailbreak process is complete. Click the Finish button.

Even though redsn0w completed it’s process your iPhone will still be finishing up. This can take up to 5 minutes. Be patient, when it’s done you will have a jailbroken iPhone 3G with Cydia/Icy on the SpringBoard.

Unlocking Process

Now if you are looking to unlock your iPhone follow these steps below.

• If you are unlocking for T-Mobile USA be sure to disable 3G.

• Run Cydia or Icy

• Add the repo repo666.ultrasn0w.com to Cydia or Icy. That last “o” is actually the number zero “0”.

• Search for ‘ultrasn0w’ in cydia or icy and install ultrasn0w.

• Reboot your iPhone 3G.

Enjoy your freshly unlocked iPhone 3G running the 3.0 software!

This is a story by the iPhone Blog. This feed is sponsored by The iPhone Blog Store.

How to: Jailbreak/Unlock iPhone 3.0 - Windows PC redsn0w Edition

Source : http://feedproxy.google.com/~r/theiphoneblog/~3/TZ...