EcranMobile.fr : l'actualité du marketing mobile

Review: Case-Mate Barely There Case for iPhone 3G




The Case-Mate Barely There case for the iPhone 3G, available for $19.95 from the TiPb iPhone Store, is designed to accomplish several things: Protect your iPhone from minor impact and abuse (e.g. bumps and scratches) Do so without adding significant bulk or making it un-pocketable (if that’s how you roll) And to look good while doing it. How well [...]

The Case-Mate Barely There case for the iPhone 3G, available for $19.95 from the TiPb iPhone Store, is designed to accomplish several things:

  • Protect your iPhone from minor impact and abuse (e.g. bumps and scratches)
  • Do so without adding significant bulk or making it un-pocketable (if that’s how you roll)
  • And to look good while doing it.

How well does it hit these targets, and what if anything could it do better? Find out in our review…

I’m not a huge fan of cases. More often than not, my iPhone goes commando in my pocket. Well, almost. I have a sticker-skin on it to protect from minor scratches since the plastic iPhone 3G backing is so prone to them. I do worry, however, that one day I’ll drop my pride and joy and that same plastic backing will chip or crack on me. Living with that fear in the back of my mind is what drove me to try out a few options, starting with one that’s as close to naked as a hard case can be.

Design

Case-Mate’s Barely There case comes in a rainbow of colors. Enough to make the latest gen iPod nano jealous. Case the rainbow. Seriously. Black, white, red, orange, purple, pink, and blue are your options. Being somewhat stalwart and sedate myself, I went with black.

It covers the back and sides of the iPhone 3G, with cutouts at the corners to increase flexibility and aid in getting it on or off. Cutouts are also provided for the controls, speaker, mic, and dock port, and a hole is cut in the back so the big Apple logo on the iPhone can represent. Fandom rejoice. Everyone else scratch your heads and hope nothing spears it right in that target spot.


For the front, in lieu of armor, Case-Mate provides a fairly typical screen protector.

Usability

Slide your iPhone in, volume buttons first, and the other side flexes and snaps into place securing your iPhone in its protective shell. Simple, direct, easy. Win.

For the screen protector — it’s a screen protector. Clean thoroughly. Apply carefully. Squeegee down deliberately.

day in, day out, the case just does what it’s supposed to from that point on — protect your iPhone from the abuse of casual use. Living up to it’s name, it often times felt like it really was barely there, adding nothing appreciable to the in-pocket experience, and even giving a tiny bit of extra, and appreciated, heft in-hand.

It’s not coated in soft-touch, so there’s really no added security when it comes to actually preventing drops, but it feels tough enough to survive a pretty good whack. And hey, if you break it, at least you’re only out an Andrew Jackson and not the heap of Ben Franklins a new iPhone would cost you.

Of course, the front is covered with only a thin plastic film, so while you still get the scratch protection, dropping it face down will offer nothing in the way of similar impact resistance.

Problems? A couple minor ones to start, mostly to do with fit and finish. The edges in the corners were left a tad sharp. Don’t get me wrong, nothing skin-piercing here, just enough to give you an annoying poke. A little extra rounding off in the factory would have been appreciated.

Likewise — and I preface this by saying I have a sticker-skin on top of my iPhone 3G which might have caused just a millimeter or so of extra girth, creating the problem — plastic interiors make me to worry about cases causing scratches as much as they prevent them. I saw some depressions on my sticker-skin. No idea if that would have translated to anything on a bare iPhone back, but a little more inside finish at the factory would be reassuring here as well.

Being a complete and single unit case, it’s not compatible with all dock-port accessories. Anything slim and at the end of a long cable, like the standard USB sync that comes with the iPhone, should do you fine. Any kind of cradle, however, will almost certainly require you to remove the case first.

Lastly, the added size, even while minimal, will of course make it incompatible with some holsters and pouches. Without a belt-clip option, this case seems pretty much targeted at people like me — those who prefer not to have cases or case-like trappings at all.

Again, just like the product name promises — this case is barely there.

Conclusion

For those who prefer nothing to come between them and our iPhones, the Case-Mate Barely There case is definitely worth a look. In the eternal compromise that comes between comfort and protection, Case-Mate strikes an excellent balance. And, since Apple in its infinitely looped wisdom only offers the iPhone 3G in black and white models, the Case-Mate is also a great way to splash some color on your unit while keeping things lean and still getting some added peace of mind.

Pros

  • Strong and flexible
  • Easy application and excellent fit
  • Wide range of color choices

Cons

  • Edges and inside could have better finish
  • Not compatible with some dock-port accessories
  • Not compatible with all holsters/pouches and no belt-clip option

TiPb Accessory Review Rating

4 star rating

This is a story by the iPhone Blog. This feed is sponsored by The iPhone Blog Store.

Review: Case-Mate Barely There Case for iPhone 3G



Source : http://feedproxy.google.com/~r/TheIphoneBlog/~3/R7...



Tags : apple, iphone
Mercredi 8 Avril 2009


Nouveau commentaire :
Twitter

Veille Twitter | Communiqués | Web Review


Recherche Archives



Inscription à la newsletter